How To Remove Carpet From Stair Stringers
How To Remove Carpet From Stair Stringers. Fill the brad holes and touch up the paint. 2 remove padding and tack strips.
Hit the other end of the pry bar with a hammer to slide the bar between the tread and the stringer. Moisten the rag with more solvent and wipe off as much of the glue residue as possible. The stairs are open riser, with the treads wrapped in carpet.
Removed Stare Tacks And Staples Using A Crowbar, Hammer And Flat Head Screwdriver (Pliers Would Work Too).
So the only exposed wood would be on the stairs. To remove the tack strip, use a 12 or 14 inch pry bar. We were thinking about removing the carpet and leaving the oak stairs exposed.any thoughts on if this is a good idea or not.
2 Remove Padding And Tack Strips.
There were so many staples. I'd seen other projects of people painting their stairs, so this is what i did with mine. Carpeted stairs consist of a carpet pad, nosing, tack strips, tread, riser and.
We Have A Carpeted Home.
Slide the new riser panel into place and attach it with a few brads using the nail gun. Some treads are a bit loose. Carpet installation on stairs with stringers.
If Needed, Cut The Carpet Into Manageable Pieces With A Razor Knife And Roll Them Into Tubes Before Placing Them Into The Trash Can.
I continued pulling up the carpeting using some combination of a razor blade to cut the carpet away from the way, the needle nose pliers to tug with to avoid staples, and the back of the hammer to pull the tacking up. Removed old nasty carpet from stairs. Moisten the rag with more solvent and wipe off as much of the glue residue as possible.
Fill The Brad Holes And Touch Up The Paint.
1 begin your carpet removal project. I wish someone out there had a similar experience. The carpet stringer doesn't appear to be structural and is notched at each.
Post a Comment for "How To Remove Carpet From Stair Stringers"